Bay Networks FastLink II Installation Guide download pdf (Page 7)

Model FS308 Fast Ethernet Switch Installation Guide

Before you begin installing your switch, prepare the installation site. Make sure

your operating environment meets the operating environment requirements of

the equipment.

To install your switch on a flat surface, you do not need any special tools. Be

sure the switch is positioned with at least 2 inches of space on all sides for

ventilation.

To install the switch on a wall, measure the distance between the mounting holes

on the back of the switch and mark the wall to match the location of the

mounting holes on the switch. At the marked location, screw into the wall the

two screws that you received with the mounting kit included in your package

contents. Be sure to choose a location that is near the devices to be connected, is

close to an electrical outlet, and provides at least 2 inches of space all around the

switch for ventilation.

Characteristic Requirement

Temperature Ambient temperature between 0

and 40

C (32

and 104

F).

No nearby heat sources such as direct sunlight, warm air

exhausts, or heaters.

Operating humidity Maximum relative humidity of 90%, noncondensing.

Ventilation Minimum 2 inches (5.08 cm) on all sides for cooling.

Adequate airflow in room or wiring closet.

Operating conditions At least 6 feet (1.83 m) to nearest source of electromagnetic

noise (such as photocopy machine or arc welder).

Power Adequate power source within 6 feet (1.83 m).

Pre

are the Site

Install the Switch

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No comments

Bay Networks FastLink II Installation Guide Page 7