Bay Networks 5782 User's Guide Page 71
- Page / 120
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Disk Drives (HDDs or SSDs)
007-5782-001 49
Disk Drives (HDDs or SSDs)
The 2U chassis supports a maximum of eight SAS or SATA disk drives. Install the drives from
left to right. Note: All disk drive bays must be populated to maintain system thermals. Drive bays
must either have a disk drive or a drive blank installed.
Figure 5-8 SGI Rackable C2108-TY11 Disk Drive Locations
The supported disk drive configurations are as follows:
• JBOD
Supports any number of drives between one and eight. The operating system is placed on the
disk drive in location 0. All other drives are data drives.
• RAID 0 (disk striping without parity)
Supports any number of drives between two and eight. Note: all drives must be the same
type. The operating system will be striped across all drives in the system. This configuration
is not recommended.
• RAID 1 (disk mirroring)
Supports exactly two drives. The two drives represents one RAID 1 logical drive. The
operating system will be installed on the drives located in Drive 0 and 1. Note: Both drives
must be the same type.
• RAID 5 (disk striping with parity)
Supports a minimum of three drives and a maximum of eight drives. Possible configurations
are 2+1, 3+1, 4+1, 5+1, 6+1 and 7+1. The operating system will be striped across all drives
in the system. Note: all drives must be the same type.
• RAID 6 (disk striping with dual parity)
Supports a minimum of four drives and a maximum of eight drives. The operating system
will be striped across all drives in the system. Note: all drives must be the same type.
• RAID 10 (mirrored disk striping)
The data is striped across one set of drives and then mirrored on another set of drives. A
minimum of four drives of the same type are required.The total number of drives must be an
even number (4, 6, 8). A total of four drives is a 2+2, six drives is a 3+3, and eight drives is a
RESET
COM PACT
Drive 0 Drive 1 Drive 2 Drive 3
Drive 4 Drive 5 Drive 6 Drive 7
- Rackable™ C2108-TY11 System 1
- User’s Guide 1
- Record of Revision 3
- 007-5782-001 vii 7
- 007-5782-001 ix 9
- Contents 10
- 007-5782-001 xi 11
- 007-5782-001 xiii 13
- 007-5782-001 xv 15
- About This Guide 17
- Related Publications 19
- Conventions 20
- Product Support 20
- Reader Comments 21
- 1. Introduction 23
- 2 007-5782-001 24
- 1: Introduction 24
- Server Chassis Features 25
- Serverboard Features 26
- Onboard Controllers/Ports 27
- Graphics Controller 27
- Other Features 27
- 6 007-5782-001 28
- 2. Server Installation 29
- Warnings and Precautions 30
- Rack Mounting Considerations 31
- Circuit Overloading 32
- Reliable Ground 32
- 007-5782-001 11 33
- Outer Rack Rails 34
- Install the Server in a Rack 35
- Check the Node Board Setup 36
- 007-5782-001 15 37
- Check the CPUs (processors) 38
- Check the System Memory 38
- Install Expansion PCI Cards 38
- Check the Drive Bay Setup 38
- Check the Airflow 39
- Supply Power to the System 39
- 3. System Interface 41
- Control Panel Buttons 42
- Control Panel LEDs 43
- 22 007-5782-001 44
- 3: System Interface 44
- Drive Carrier LEDs 45
- 4. System Safety 47
- 26 007-5782-001 48
- 4: System Safety 48
- General Safety Precautions 49
- ESD Precautions 50
- 5. Advanced Serverboard Setup 51
- Handling the Node Board 52
- Connecting the Control Panel 53
- Node Board Details 54
- Installing Memory 56
- 007-5782-001 35 57
- Figure 5-3 DIMM Installation 57
- 36 007-5782-001 58
- 5: Advanced Serverboard Setup 58
- 007-5782-001 37 59
- Memory Configuration 60
- Front of Chassis 61
- Rear of Chassis 61
- 40 007-5782-001 62
- Memory DIMM Layout 63
- Memory DIMM Rules 64
- 007-5782-001 43 65
- 44 007-5782-001 66
- 007-5782-001 45 67
- 46 007-5782-001 68
- 007-5782-001 47 69
- 48 007-5782-001 70
- Disk Drives (HDDs or SSDs) 71
- PCI Expansion Slots 72
- 007-5782-001 51 73
- 52 007-5782-001 74
- Memory Errors 75
- Chassis Service Information 76
- Static-Sensitive Device 78
- Control Panel 78
- System Fans 79
- Replacing System Fans 80
- HDD Drive Installation 80
- 007-5782-001 59 81
- 60 007-5782-001 82
- Hard Drive Backplane 83
- DVD-ROM Drive Installation 83
- Power Supply 84
- Starting BIOS Setup Utility 85
- Starting the Setup Utility 86
- Main Setup 86
- System Time/System Update 87
- Serverboard 88
- Processor 88
- System Memory 88
- Advanced Setup Configurations 89
- Boot Features 90
- Power Configuration 91
- Processor and Clock Options 92
- 007-5782-001 71 93
- 72 007-5782-001 94
- Advanced Chipset Control 95
- North Bridge Configuration 97
- SouthBridge Configuration 98
- I/O Virtualization 98
- IDE and SATA Configuration 99
- PCI/PnP Configuration 100
- Super IO Device Configuration 101
- Remote Access Configuration 102
- Hardware Health Monitor 103
- 82 007-5782-001 104
- System Fan Monitor 105
- ACPI Configuration 106
- IPMI Configuration 107
- View BMC System Event Log 107
- Set LAN Configuration 108
- IP Address Configuration 108
- MAC Address Configuration 109
- Security Settings 110
- 007-5782-001 89 111
- 90 007-5782-001 112
- Boot Configuration 113
- Hard Disk Drives 114
- Removable Drives 114
- CD/DVD Drives 114
- Exit Options 115
- Discard Changes and Exit 116
- Discard Changes 116
- Load Optimal Defaults 116
- Load Fail-Safe Defaults 116
- A. Technical Specifications 117
- º to 35º C (50º to 95º F) 118
- º to 70º C (-40º to 158º F) 118
- B. BIOS Error Codes 119
Related products and manuals for Networking Bay Networks 5782
Networking Bay Networks CM 100 Service Manual
(200 pages)
(200 pages)
Networking Bay Networks 5000 User Manual
(109 pages)
(109 pages)
© 2020, manymanuals.com. All rights reserved. | 1.645 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals